The ada mandates that baby changing stations be present in both men s and women s restrooms and must be placed at a height of 27 inches from the floor.
Baby changing station mounting height ada.
Listed below are standards for baby changing stations.
Figure 308 2 a forward reach.
Five tips for ada compliance.
The americans with disabilities act ada was created to ensure access to buildings and structures for people with disabilities.
Where a forward reach in unobstructed the high forward reach shall be 48 inches 1220 mm maximum and the low forward reach shall be 15 inches 380 mm minimum above the finish floor or ground.
Recess mounted stainless steel clad baby changing station is the premier choice for upscale restroom facilities.
The ada requires 59 inches and 27 inches your manufacturer s instruction sheet should be consulted for recommended mounting heights.
Complete the design by providing the required amount of toe clearance underneath the lavatory of 17 inches 430mm to 25 inches 635mm maximum.
Check your local code for addition information and requirements.
Knee clearance must extend 25 inches under a changing table and the unit must be 9 inches above the finish of the ground.
The ada americans with disabilities act has set requirements for baby changing stations.
This is required so patrons using wheelchairs can easily access the unit as well as open and close the changing station.
The ada standards are issued by the department of justice doj and the department of transportation dot.
Recess mounted plastic baby changing station with stainless steel flange is a stylish and safe option for restroom facilities.
Toe clearance at least 9 inches 230mm above the finish floor must be provided for the full depth.
Below is a diagram from diaper depot about mounting baby changing stations.
Any change to restroom functionality inevitably turns to the question of americans with disabilities act ada compliance.
There are specific mounting heights and other requirements of baby changing stations in restrooms says ada compliance expert joan stein of stein consulting inc pittsburgh.
Baby changing stations types.
For horizontal changing stations the ada requires that the unit protrude no more than 4 from the wall and be no higher than 27 inches from the floor.
Baby changing stations should meet the requirements of the ada.
Protruding objects units are not to protrude more than 4 inches from the wall when closed.
They have to be mounted so that the very top of the changing table surface when it is opened cannot be any higher than 34 inches off the floor she says.
Install at the perfect height.
Oval baby changing stations.
Horizontal stainless steel recess mounted kb110 ssre.